Share:


Wind tunnel calibration, corrections and experimental validation for fixed-wing micro air vehicles measurements

    Ahmed Aboelezz Affiliation
    ; Yunes Elqudsi Affiliation
    ; Mostafa Hassanalian Affiliation
    ; Ahmed Desoki Affiliation

Abstract

The increase in the number of Unmanned Aerial Vehicles (UAVs) and Micro Air Vehicles (MAVs), which are used in a variety of applications has led to a surge in low Reynolds number aerodynamics research. Flow around fixedwing MAVs has an unusual behavior due to its low aspect ratio and operates at low Reynolds number, which demanded to upgrade the used wind tunnel for this study. This upgrade enables measuring the small aerodynamics forces and moment of fixed-wing MAVs. The wind tunnel used in this work is upgraded with a state of art data acquisition system to deal with the different sensors signals in the wind tunnel. For accurate measurements, the sting balance, angle sensor, and airspeed sensor are calibrated. For validation purposes, an experiment is made on a low aspect ratio flat plate wing at low Reynolds number, and the measured data are corrected and compared with published results. The procedure presented in this paper for the first time gave a detailed and complete guide for upgrading and calibrating old wind tunnel, all the required corrections to correct the measured data was presented, the turbulence level correction new technique presented in this paper could be used to estimate the flow turbulence effect on the measured data and correct the measured data against published data.


First published online 17 February 2020

Keyword : wind tunnel, sting balance, calibration, uncertainty analysis, low aspect ratio, low Reynolds number

How to Cite
Aboelezz, A., Elqudsi, Y., Hassanalian, M., & Desoki, A. (2020). Wind tunnel calibration, corrections and experimental validation for fixed-wing micro air vehicles measurements. Aviation, 23(4), 104-113. https://doi.org/10.3846/aviation.2019.11975
Published in Issue
Feb 17, 2020
Abstract Views
2633
PDF Downloads
4491
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

References

Aboelezz, A., et al. (2019). Design, experimental investigation, and nonlinear flight dynamics with atmospheric disturbances of a fixed-wing micro air vehicle. Aerospace Science and Technology, (2019), 105636. https://doi.org/10.1016/j.ast.2019.105636

AEROLAB LLC. (2019). Aerolab Educational Wind Tunnel (EWT) owner’s manual. https://www.aerolab.com/products/educational-wind-tunnel-ewt/

Allan, M. R., Badcock, K. J., Barakos, G. N., & Richards, B. E. (2004). Wind-tunnel interference effects on a 70 delta wing. The Aeronautical Journal, 108(1088), 505–513. https://doi.org/10.1017/S0001924000000336

Bentley, J. P. (2005). Uncertainty in Measurement System: The ISO guide. National Measurement Institute, Sydney, Australia.

Boutemedjet, A., Samardžić, M., Ćurčić, D., Rajić, Z., & Ocokoljić, G. (2018). Wind tunnel measurement of small values of rolling moment using six-component strain gauge balance. Measurement, 116, 438–450. https://doi.org/10.1016/j.measurement.2017.11.043

Boyle, M. T. (1988, February). Low speed wind tunnel testing. In Fourth annual IEEE semiconductor thermal and temperature measurement symposium (pp. 31–39). San Diego, CA, USA. IEEE.

Cheung, C. K., & Melbourne, W. H. (1980). Wind tunnel blockage effects on a circular cylinder in turbulent flows. In 7th Australasian Conference on Hydraulics and Fluid Mechanics 1980: Preprints of Papers (p. 127). Institution of Engineers, Australia.

Cruz, E. (2012). The effect of turbulence on micro air vehicle airfoils (PhD). Aerospace, Mechanical and Manufacturing Engineering, RMIT University.

Dickinson, M. H., Lehmann, F. O., & Sane, S. P. (1999). Wing rotation and the aerodynamic basis of insect flight. Science, 284(5422), 1954–1960. https://doi.org/10.1126/science.284.5422.1954

Erm, L. P., & Ferrarotto, P. (2009). Development of a five-component strain-gauge balance for the DSTO water tunnel (No. DSTO-GD-0597). Defence science and technology organisation Victoria (Australia) air vehicles division.

Hassanalian, M., & Abdelkefi, A. (2017). Classifications, applications, and design challenges of drones: A review. Progress in Aerospace Sciences, 91, 99–131. https://doi.org/10.1016/j.paerosci.2017.04.003

Hassanalian, M., & Abdelkefi, A. (2017). Conceptual design and analysis of separation flight for an unmaned air vehicle to five micro air vehicles. In 55th AIAA Aerospace Sciences Meeting (p. 0240). Grapevine, Texas. https://doi.org/10.2514/6.2017-0240

Hassanalian, M., & Abdelkefi, A. (2017). Design, manufacturing, and flight testing of a fixed wing micro air vehicle with Zimmerman planform. Meccanica, 52(6), 1265–1282. https://doi.org/10.1007/s11012-016-0475-2

Hassanalian, M., Khaki, H., & Khosravi, M. (2015). A new method for design of fixed wing micro air vehicle. Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 229(5), 837–850. https://doi.org/10.1177/0954410014540621

Hassanalian, M., Rice, D., Johnstone, S., & Abdelkefi, A. (2018). Performance analysis of fixed wing space drones in different solar system bodies. Acta Astronautica, 152, 27–48. https://doi.org/10.1016/j.actaastro.2018.07.018

Hrad, P. M. (2010). Conceptual design tool for fuel-cell powered micro air vehicles (No. AFIT/GAE/ENY/10-M12). Air force institute of Tech Wright-Patterson AFB OH graduate school of engineering and management.

Lee, T., & Gerontakos, P. (2004). Investigation of flow over an oscillating airfoil. Journal of Fluid Mechanics, 512, 313–341. https://doi.org/10.1017/S0022112004009851

Liu, Z., Dong, L., Zhao, J., & Yan, G. (2015). Components interaction effect evaluation of a small-capacity five-component internal balance system. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 229(1), 125–135. https://doi.org/10.1177/0954406214531747

Mueller, T. J. (2000). Aerodynamic measurements at low raynolds numbers for fixed wing micro-air vehicles. Notre Dame university in dept of aerospace and mechanical engineering.

Nakata, T., Liu, H., Tanaka, Y., Nishihashi, N., Wang, X., & Sato, A. (2011). Aerodynamics of a bio-inspired flexible flapping-wing micro air vehicle. Bioinspiration & Biomimetics, 6(4), 045002. https://doi.org/10.1088/1748-3182/6/4/045002

Ohanian, O., Hickling, C., Stiltner, B., Karni, E., Kochersberger, K., Probst, T., ... & Blain, A. (2012, April). Piezoelectric morphing versus servo-actuated MAV control surfaces. In 53rd AIAA/ASME/ASCE/AHS/ASC Structures, Structural Dynamics and Materials Conference 20th AIAA/ASME/AHS Adaptive Structures Conference 14th AIAA. Vancouver, British Columbia, Canada (p. 1512). https://doi.org/10.2514/6.2012-1512

Pass, C. (1987, January). A wake blockage correction method for small subsonic wind tunnels. In 25th AIAA Aerospace Sciences Meeting. Delft, The Netherlands (p. 294). https://doi.org/10.2514/6.1987-294

Pope, A., & Rae, W. H. (1984). Low-speed wind tunnel testing. Wiley-Interscience.

Rezaei, A. S., & Taha, H. E. (2019). Transition regime and its effects on the unsteady aerodynamic characteristics of a pitching airfoil. In AIAA Scitech 2019 Forum (p. 0302). San Diego, California. https://doi.org/10.2514/6.2019-0302

Shindo, S. (1995). Simplified tunnel correction method. Journal of Aircraft, 32(1), 210–213. https://doi.org/10.2514/3.46705

Silverstein, A., & White, J. A. (1937). Wind-tunnel Interference with particular reference to off-center positions of the wing and to the downwash at the tail. Annual Report – National Advisory Committee for Aeronautics, Vol. 22.

Stewart, K., Wagener, J., Abate, G., & Salichon, M. (2007). Design of the air force research laboratory micro aerial vehicle research configuration. In 45th AIAA Aerospace Sciences Meeting and Exhibit (p. 667). Reno, Nevada. https://doi.org/10.2514/6.2007-667

Torres, G. E., & Mueller, T. J. (2004). Low aspect ratio aerodynamics at low Reynolds numbers. AIAA Journal, 42(5), 865–873. https://doi.org/10.2514/1.439

Torres, G., & Mueller, T. J. (2000, July). Micro aerial vehicle development: design, components, fabrication, and flight-testing. In AUVSI Unmanned Systems 2000 Symposium and Exhibition (pp. 11–13). Japan.

Traub, L. W. (2018). Design of a low-cost rapid-prototyped wind-tunnel balance. Journal of Aircraft, 55(5), 2149–2153. https://doi.org/10.2514/1.C034982

Ulbrich, N., & Gisler, R. (2013, January). A baseline load schedule for the manual calibration of a force balance. In 51st AIAA Aerospace Sciences Meeting including the New Horizons Forum and Aerospace Exposition (p. 1017). Grapevine (Dallas/Ft. Worth Region), Texas. https://doi.org/10.2514/6.2013-1017

Wang, S., Zhou, Y., Alam, M. M., & Yang, H. (2014). Turbulent intensity and Reynolds number effects on an airfoil at low Reynolds numbers. Physics of Fluids, 26(11), 115107. https://doi.org/10.1063/1.4901969